14. Cutting height pedal
The deck cutting height is obtained by
pressing the foot pedal forward to lift the
deck. To lower the deck, you apply pressure
to the top side of the foot pedal and allow it to
pivot while allowing the lift arm to rotate to the
rear of the unit. To stop in a desired cutting
position, rotate the foot pedal down into the
notch in the height plate. The cutting height
range is from 1 1/2" (38 mm) to 4 1/2"
(114 mm) in 1/2" (13 mm) increments. The
heights are measured from the ground up to
the blade tip with the engine not running.
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all
four tires is the same 15 psi (1 bar).
Accessories
For mulching, there is a BioClip attachment
available. This is mounted underneath the
mower deck and consists of control plates
and BioClip blades.
CONTROLS
1. Foot pedal
2. Lift arm
3. Height plate
Cutting height pedal
BioClip attachment
Cz-8
8011-566
23
English-