Battery - Husqvarna Z4818BIA/968999250 Operator's Manual

Battery

Your mower is equipped with a maintenance
free battery and does not need servicing.
However, periodic charging of the battery with
an automotive type battery charger will
extend its life.
• Keep battery and terminals clean.
• Keep battery bolts tight.
• Recharge at 6-10 amperes for 1 hour
To clean battery and terminals
Corrosion and dirt on the battery and
terminals can cause the battery to "leak"
power.
1. Open the terminal access doors.
2. Disconnect BLACK battery cable first,
then the RED battery cable and remove
the battery from the machine.
3. Rinse the battery with plain water and
dry.
4. Clean terminals and battery cable ends
with wire brush until shiny.
5. Coat terminals with grease or petroleum
jelly
6. Reinstall battery.
Replacing battery
1. Lift Seat and rotate forward.
2. Open terminal access doors.
3. Using two 1/2" wrenches disconnect
BLACK battery cable then RED battery
cable.
4. Using 7/16" wrench, remove terminal
guard.
5. Carefully remove the battery from the
mower.
6. Install new battery with terminals in the
same position as the old battery.
7. Reinstall terminal guard.
8. First connect RED battery cable to
positive (+) battery terminal with hex bolt
and hex nut.
MAINTENANCE
IMPORTANT INFORMATION
Do not attempt to open or remove caps
or covers. Adding or checking level of
electrolyte is not necessary.
Always use two wrenches for the
terminal screws
1. Terminal guard
2. Terminal access doors
Battery installation
Always use protective glasses
when handling the battery.
WARNING!
Do not short battery terminals
by allowing a wrench or any
other object to contact both
terminals at the same time.
Before connecting battery,
remove metal bracelets,
wristwatch bands, rings, etc.
Positive terminal must be
connected first to prevent
sparks from accidental
grounding.
CZ-22
37
English-