Husqvarna Z4818BIA/968999250 Operator's Manual page 46

• Carefully roll the belt over the top of the
cutter housing pulleys.
• Remove the belt from around the electric
clutch on the engine shaft.
• The belt can now be removed.
Deck belt installation
NOTE: For ease in installing the deck belt,
refer to the routing decal on the front edge of
the deck.
• Wrap the deck belt around the electric
clutch that is located on the engine shaft.
• Push the rest of the belt through the
IZT(Integraded Zeroturn Transaxle)
support and up onto the deck.
• Starting on the right hand side of the
deck, wrap the belt around the large right
side idler, right cutter housing pulley,
small center idler, center pulley, left side
pulley and then around the large left side
idler.
• The belt will be loose at this point.
• Secure the belt tension relief lever and
reengage it in the lock bracket.
44
English-
MAINTENANCE
Tension relief lever
CZ-20