Side Burner Hose Quick-Connect - Jenn-Air 730-0337 Instructions Manual

SIDE BURNER HOSE QUICK-CONNECT

Estimated Assembly Time: Approximately 5-7 minutes
Required Tools: Phillips Screwdriver
1. Insert the side burner hose with female sleeve through side panel of cart (Top drawing).
2. Push the sleeve of the female socket back and insert the male end of connector. Release the sleeve.
3. Push the male end into the socket until the sleeve snaps forward to lock the plug in place.
4. To disconnect, push the sleeve back and pull the female end off (bottom drawing).
WARNING
1. Insert the coupling half (socket) into the gas
supply line in accordance with ANSI
Z223.1/NFPA 54 FUEL gas code.
2. Prior to inserting the plug, test the connection for
leaks using the leak test instructions on page 11.
After the leak test, rinse the connection with
clean water to remove any corrosive residue.
3. Do not use an open flame to test for leaks.
400
300 50 0
200 600
10 0 700
800
8