Side Burner Hose Quick-Connect - Jenn-Air 720-0171 Instructions Manual

SIDE BURNER HOSE QUICK-CONNECT

1. The side burner hose connects the side burner manifold directly to the main grill manifold.
The side burner hose comes from the factory connected to the main grill manifold.
2. To connect the hose to the side burner manifold, push the hose through the hole in the side
panel of the main grill cart, through the "pie" piece with the granite top, and through the side
panel of the side burner cart.
3. Directions for connecting the Quick-Connect fitting to the side burner manifold are listed below.
Once the connection is made, leak test the fitting using the method described in the Leak
4.
Testing Section (page 13).
S O C K E T
S LE E V E
S O C K E T
S LE E V E
P LU G
(FIG . 1)
(FIG . 2)
P LU G
(FIG . 3)
8
WARNING
1. Install coupling half (socket) on gas
supply line
NFPA54/ANSI Z223.1FUEL gas code
2. Prior to inserting plug test the
connection for leaks only with leak
test solution. Rinse with clean water
after leak test
corrosive residue. Do not use open
flame to test for leaks.
1. To connect-push back sleeve of
socket (fig.1)
2. Hold the Plug and insert into
the socket (fig.2), release sleeve.
3. Push Plug until sleeve snaps
forward locking Plug in Socket
(fig.3) (THIS TURNS ON GAS
AUTOMATICALLY)
4. To disconnect, shut off the gas
supply, push sleeve back and pull
out plug. (THIS AUTOMATICALLY
SHUTS OFF GAS)
in accordance with
to remove any