Side Burner Hose Quick Disconnect Assembly - Jenn-Air 730-0512 Manual

SIDE BURNER HOSE QUICK DISCONNECT ASSEMBLY

Estimated Assembly Time: Approximately 5 minutes
No Tools Required
1. Insert the side burner hose with female sleeve through side panel of cart (A).
2. Push the sleeve of the female socket back and insert the male end of the connector. Release the
sleeve.
3. Push the male end into the socket until the sleeve snaps forward to lock the plug in place.
4. To disconnect, push the sleeve back and pull out the male end (B).
A
WARNING
1. Attach the coupling half (socket) to the gas supply line in accordance with ANSI Z223.1/NFPA 54 FUEL gas
code.
2. Prior to inserting the plug, test the connection for leaks following the leak test instructions on page 15. After the
leak test is completed, rinse the connection with clean water to remove any corrosive residue.
3. Do not use open flame to test for leaks.
3 0 0 4 0 0 5 0 0
2 0 0 6 0 0
1 0 0
8 0 0 7 0 0
8
B