Table of Contents
Advertisement
1. Ground Speed Lever
Located in the center of the console. Controls
the forward speed of the mower. Push the
lever forward if you want to go faster, pull it
back to go slower or pull it all the way back to
the stop postion.
To begin motion, the operator must move the
ground speed lever forward before
disengaging the neutral lock bail.
Ground Speed Lever Stop is the adjustment
screw placed on the front edge of the console
panel. It is used to insure ground speed lever
does not over travel motion control levers into
revese.
2. Choke Control
The choke control is used for cold starts to
provide the engine with a richer fuel mixture.
For cold starts the choke control should be
pulled out.
Push the choke control gradually in when the
engine is started till the engine runs smoothly.
Do not use the choke control when starting a
warm engine.
3. Ignition Switch
The ignition key switch is placed on the
console panel and is also used to start the
machine when it is equipped with an electric
starter.
IMPORTANT INFORMATION
Do not run the starter for more than five
seconds each time. If the engine does not
start, wait about 10 seconds before re-
trying.
16
English-
CONTROLS
Ground Speed Lever
Choke control
Ignition key
8011-415
8011-690
8011-689
Advertisement
Table of Contents
