Table of Contents
Advertisement
Lifting Lever for the Mower Deck
The lifting lever is used to place the mower
deck in the transport position or one of the 7
different cutting height positions.
The cutting height is set by pulling back the
Deck Height Lever and placing the Height
Adjustment Pin in the hole for the desired
cutting height. The pin is then locked on the
inside (hidden in the illustration) with the
supplied locking pin.
1.
Pull the lever backward to the locked
position to engage the transport position.
The deck is then raised and secured by
the Transport Position Latch.
2.
Counter hold and disengage the
Transport Position Latch, move the lifting
lever forward toward the Height
Adjustment Pin to engage the pre-set
cutting height. The deck is lowered to its
pre-set cutting mode.
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all
four tires is correct.
Pump release valves
IMPORTANT INFORMATION
Only rotate valve 1/4 to 1/2 turn to release
system.
Tighten the valve moderately.
Do not overtighten the valve when
closing, this can damage the valve seat.
Pump release valves located at the pumps.
Used to release the system so the machine
may be moved by hand when not running.
Use a 5/8" wrench to open valve.
22
English-
CONTROLS
1. Deck height lever
2. Transport position latch
3. Height adjustment pin
Deck height lever
Pump release valve
8011-401
8011-507
Advertisement
Table of Contents
