Maintenance; Maintenance Schedule - Husqvarna WH4817EFQ2, WH5219EFQ Operator's Manual

Maintenance

Maintenance Schedule

The following is a list of maintenance procedures that must be performed on the machine. For those points
not described in this manual, visit an authorized service workshop. An annual service carried out by an
authorized service workshop is recommended in order to maintain your machine in the best possible
condition and to ensure safe operation.
Read Safety Instructions section "Safety Instructions" on page 7.
1)
First change after 8 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.
and replacement are required more often.
= Described in this manual
= Not described in this manual
Maintenance
Check for fuel and oil leakages
Check the engine's oil level (every refueling)
Front and rear tires: Damage, Pressure
Check the fuel pump's air filter
Check battery
Check the safety system
Check/clean the engine's cooling air intake
Check the cutting deck
Check pump compartment
Check underside of rear deck
Check hardware (screws, nuts, etc.)
Start the engine and blades, listen for unusual
sounds
Clean under the mower deck
Inspect/Replace blades
Check the hydraulic system's oil level
Check the condition of belts, belt pulleys, etc.
Check for damage
Thoroughly clean around the engine
Thoroughly clean around the hydraulic system
Clean around belts, belt pulleys, etc.
Clean the engine's cooling air intake
MAINTENANCE
3)
For daily use, the machine should be lubricated twice weekly.
2)
Daily Weekly
mainte- mainte-
nance nance
Page Before After
-
52
42
42
37
39
40
44
43
43
47
-
47
48
54
43
-
-
-
-
40
2)
In dusty conditions, cleaning
4)
Performed by authorized service workshop.
At Maintenance interval
least in hours
once
each
25 50 100
year
English-
300
35