Camera Installation - Samsung SEW-3030 User Manual

Side Controls
9. Sound Alarm Trigger – Adjust the sensitivity knob to set the sound alarm
sensitivity. The receiver will beep to alert you when the sound is above a preset
sound level. Adjust to increase or decrease the level of sensitivity.
10. Camera ON/OFF Switch – Turns the camera ON or OFF. When the
camera is turned on, the LED light would appear green. After 2 seconds, it goes
out.
11. Volume – Increase or decrease the speaker volume of the camera.
12. Camera ON and low battery indication – Turn on the camera, the LED
light will blink green once; Low battery, the LED will blink repeatedly.
13. Night vision sensor – Detects light levels where the camera is placed.

Camera Installation

Before you install the camera, carefully plan where and how it will be positioned,
and where you will route the cable that connects the camera to the power
adaptor.
Before starting permanent installation, verify its performance by observing the
image on the receiver when camera is positioned in the same location/position
where it will be permanently installed and the receiver is placed in the location
where it will be used most of the time.
Installation Warnings
Aim the camera(s) to best optimize the viewing area: Select a location for the
camera that provides a clear view of the area you want to monitor, which is free
from dust, and is not in line-of-sight to a strong light source or direct sunlight.
Avoid installing the camera where there are thick walls or obstructions between
the camera and the receiver.
11