Honda CBR600RR 2007 Owner's Manual page 157

Drive Chain
5. Check rear axle alignment by making
sure the chain adjuster index mark ( )
aligns with the scale graduations ( ) on
both sides of the swingarm.
Both marks should correspond. If the
axle is misaligned, turn the right or left
adjusting bolt until the marks are
aligned and recheck chain slack.
6. Tighten the rear axle nut to the
specified torque:
83 lbf·ft (113 N·m , 11.5 kgf·m)
If a torque wrench is not used for this
installation, see your Honda dealer as
soon as possible to verify proper
assembly. Improper assembly may lead
to a loss of braking capacity.
148
Servicing Your Honda
7. Tighten the drive chain adjusting bolts
4 lightly by turning it counterclockwise,
5 then tighten the drive chain lock nuts by
holding the drive chain adjusting bolts
with a wrench.
8. Recheck drive chain slack (page
Lubrication
Refer to
Lubricate every 500 miles (800 km) or
sooner if chain appears dry. Lubricant:
SAE 80 or 90 gear oil
Saf ety Precautions
144 ).
on page 70 .