Honda CBR600RR 2007 Owner's Manual page 156

RIGHT SIDE
(1)
(5)
(1) rear axle nut
(2) drive chain
lock nut
(3) drive chain
adjusting bolt
1. Place the motorcycle on its side stand
with the transmission in neutral and the
ignition switch OFF.
2. Loosen the rear axle nut ( ).
(3)
(2)
(4)
(4) chain adjuster
index mark
(5) scale
graduations
1
3. Loosen the drive chain lock nuts ( ) on
both sides of the swingarm.
4. Turn both drive chain adjusting bolts
( ) an equal number of turns until the 3
correct drive chain slack is obtained.
Turn the drive chain adjusting bolts
counterclockwise to tighten the chain,
Turn the drive chain adjusting bolts
clockwise and push the rear wheel
toward the front to provide more slack.
Adjust the chain slack at a point
midway between the front sprocket and
the rear wheel sprocket.
Roll the motorcycle forward. Stop and
place it on its side stand. Recheck chain
slack. Chain slack should allow the
following vertical movement by hand:
1 3/16 1 9/16 in (30 40 mm)
Servicing Your Honda
Drive Chain
2
(cont'd)
147