Steering Control Shafts; Mower Deck Struts; Changing The Oil Filter - Husqvarna LZ30, LZ30C Operator's Manual

Steering Control Shafts

Tip the driver's seat.
Lubricate with a grease gun, one zerk for each
steering control shaft, until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

Mower Deck Struts

Lubricate with a grease gun, one zerk for each strut,
until the grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

Changing the Oil Filter

1. Drain the engine oil in accordance with the
work description under the heading "Engine
Oil/Change Engine Oil".
2. Remove the oil fi lter. If necessary, use a fi lter
remover.
3. Wipe new, clean engine oil onto the seal for
the new fi lter.
4. Mount the fi lter by hand with a ¾ turn.
5. Run the engine warm, then check that there
are no leaks around the oil fi lter seal.
6. Check the oil level in the engine, top up
if necessary. The oil fi lter holds 0.2 qt.
(0.2 liters) of oil.
56
-
English
LUBRICATION
Lubricating the steering control shafts
Lubricating struts
Changing the oil fi lter
8011-578
8011-577-1
8011-745