Power Trim And Tilt Switch On Bottom Engine Cowling; Variable Trolling Rpm Switches - Yamaha F50F Owner's Manual

outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch " " (down) tilts the outboard mo-
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 41 and 43.
UP
DN
EMU26151
Power trim and tilt switch on bottom
" (up) trims the
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
motor up, then tilts it up. Pressing the switch
"
and trims it down. When the switch is re-
leased, the outboard motor will stop in its
current position.
EWM01030
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
ZMU03938
NOTE:
For instructions on using the power trim and
tilt switch, see page 43.
EMU30900

Variable trolling RPM switches

The trolling speed can be adjusted when the
Basic components
" (up) trims the outboard
" (down) tilts the outboard motor down
WARNING
UP
DN
1. Power trim and tilt switch
1
ZMU03634
15