11
SERVICE WORK ON THE CHASSIS
11.8
Installing the fork legs
(EXC EU, EXC AUS, all XC‑W models)
–
Release screws
–
Release screws
101323-10
(EXC SIX DAYS)
–
Release screws
–
Release screws
101324-10
x
Main work
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
101325-10
(EXC EU, EXC AUS, all XC‑W models)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
101323-11
(EXC SIX DAYS)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
101324-11
–
Position brake caliper, and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Refit the headlight mask with the headlight. (
101326-10
. Take out the left fork leg.
4
. Take out the right fork leg.
5
. Take out the left fork leg.
4
. Take out the right fork leg.
5
toward the front.
1
.
2
M8
.
3
M8
.
2
M8
.
3
M8
M8
.
5
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
17 Nm
(12.5 lbf ft)
12 Nm
(8.9 lbf ft)
.
4
25 Nm
Loctite
®
243™
(18.4 lbf ft)
p. 87)
46