Miele CM 5200 Operating Instructions Manual page 70

Problem solving guide
Unusual performance of the coffee machine
Problem
Only very little
coffee or nothing at
all is dispensed,
although a drink has
been selected.
Water stopped
flowing whilst
programming the
amount to use.
The coffee machine
does not rinse itself
out when switched
on.
There is a lot of
residual "coffee
water" in the waste
container.
70
Possible cause and remedy
The filters in the brew unit are blocked.
^ Clean the brew unit (see "Cleaning the brew unit")
^ Degrease the brew unit (see "Cleaning the brew unit")
The maximum amount possible was reached. Preparation
is halted and the maximum portion size possible will be
saved.
or
There is insufficient water in the water container. The
programming the amount process will be cancelled and
the portion sizes will not be saved.
^ Fill the water container with fresh tap water and replace it
in the machine.
^ Repeat the procedure for programming the amount.
This is not a fault.
If the coffee machine still has an operating temperature
higher than 60 °C , then rinsing will not take place.
The coffee is too coarsely ground.
^ Set the grinder on a finer setting (see "Grinder setting").
^ If necessary, adjust the amount of coffee (see "Amount of
coffee").