Adjusting The Pc Image Automatically; Adjusting The Pc Image Manually - Sharp Aquos LC-40LE820X Operation Manual

Connecting a PC

Adjusting the PC image automatically

This function enables the screen to be automatically
adjusted to its best possible condition when the
analogue terminals of the TV and PC are connected
with a commercially available RGB cable, etc.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "Option".
3
Press a / b to select "Terminal setting", and
4
then press ENTER.
Press a / b to select "PC input" and then
5
press ENTER.
Press a / b to select "Auto sync.".
6
Press c / d to select "Yes", and then press
7
ENTER.
• Auto Sync. starts.
CH list
:Enter
NOTE
• Auto Sync. is likely to succeed when an input PC image
has wide vertical stripes (e.g. pattern with high contrast
stripes, or cross-hatched).
It may fail when an input PC image is solid (low contrast).
• Be sure to connect the PC to the TV and switch it on
before starting Auto Sync.
56
40LE820X_en_au.indd 56 40LE820X_en_au.indd 56
Menu
Setup
:Back
PC input
Auto sync.
Yes No
A
[Video + Audio]

Adjusting the PC image manually

Ordinarily you can easily adjust the picture as
necessary to change image position using Auto Sync.
In some cases, however, manual adjustment is needed
to optimise the image.
Press MENU and the MENU screen displays.
1
Press c/d to select "Setup".
2
Press b/c/d to select "Option".
3
Press a / b to select "Terminal setting", and
4
then press ENTER.
Press a / b to select "PC input" and then
5
press ENTER.
Press a / b to select "Fine sync.", and then
6
press ENTER.
Press a / b to select a specifi c adjustment
7
item among "H-Pos.", "V-Pos.", "Clock" and
"Phase".
Fine sync.
Image position adjustment, etc.
H-Pos.
-1 -89
V-Pos.
0 -37
Clock
0 -90
Phase
-12 -20
Reset
Selected item
H-Pos. Centres the image by moving it to the left
or right.
V-Pos. Centres the image by moving it up or
down.
Clock Adjusts when the image fl ickers with
vertical stripes.
Phase Adjusts when characters have low
contrast or when the image fl ickers.
Press c / d to adjust the item to your desired
8
position.
NOTE
• For resetting all adjustment items to the factory preset values, press
a/b to select "Reset", and then press ENTER.
• Images may not be displayed properly depending on the settings
and/or input signals.
+90
+6
+90
+20
Description
2010/06/18 16:12:47 2010/06/18 16:12:47