Table of Contents
Advertisement
Key
(2) Keys
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping
puposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
Utility knife
Tire pressure gauge
Pliers
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM
CAR TON
UNPACK CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
•
Check for any additional loose parts or cartons and
remove.
CHECK BATTERY (See Fig. 1)
•
Lift hood to raised position.
NOTE: If this battery is put into service after month and year
indicated on label (L) (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
UNASSEMBLED PARTS
ASSEMBLY
(1) 9/16" wrench
(1) 3/4" wrench
(1) Oil Drain Tube
L
ADJUST SEAT (See Fig. 2)
•
Sit in seat.
•
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
•
Release lever to lock seat in position.
A
5
Slope Sheet
02931
Fig. 1
Fig. 2
Advertisement
Table of Contents
