Checking Drive Belts; Checking And Replacing Fuses - Hyundai Accent Owner's Manual

CHECKING DRIVE BELTS

G190A01A-AAT
Water Pump Pulley
0.2~0.24 in.
(5.1~6 mm)
Alternator
Pulley
Crankshaft Pulley
Drive belts should be checked periodically for
proper tension and adjusted if necessary. At the
same time, belts should be examined for cracks,
wear, fraying or other evidence of deterioration
and replaced if necessary.
Belt routing should also be checked to be sure
there is no interference between the belts and
other parts of the engine. After a belt is replaced,
the new belt should be adjusted again after two
or three weeks to eliminate slack resulting from
initial stretching after use.
lcflhma-6.p65 19
CHECKING AND REPLACING
FUSES
G200A01A-AAT
Replacing a Fusible Link
Open-
Replace
HTB186
A fusible link will melt if the electrical circuits
from the battery are ever overloaded, thus pre-
venting damage to the entire wiring harness.
(This could be caused by a short in the system
drawing too much current.) If this ever happens,
have a Hyundai dealer determine the cause,
repair the system and replace the fusible link.
The fusible links are located in a relay box for
easy inspection.
DO-IT-YOURSELF MAINTENANCE
!
CAUTION:
When replacing a fusible link, never use
anything but a new fusible link with the same
or lower amperage rating. Never use a piece
of wire or a higher-rated fusible link. This
could result in serious damage and create a
Good
fire hazard.
G200A01A
9/24/04, 11:44 AM
6
19