Hyundai Accent Owner's Manual page 177

6
DO-IT-YOURSELF MAINTENANCE
24
6. Draw the vertical line (through the center of
each headlight) and the horizontal line
(through the center of each headlight) on the
aiming screen.
And then, draw a parallel line at 0.8 in.(21
mm) under the horizontal line.
7. Adjust each cut-off line of the low beam to
the parallel line with a phillips screwdriver
- VERTICAL AIMING
!
WARNING:
Horizontal aiming should be adjusted by an
authorized Hyundai dealer.
lcflhma-6.p65 24
G290B02A-AAT
Adjustment After Headlight Assembly
Replacement
Vertical line
0.8 in. (21mm)
W
Horizontal line
"P"
H
Cut-off line
Ground
line
L
H
G290B01A-1
If the vehicle has had front body repair and the
headlight assembly has been replaced, the head-
light aiming should be checked using an aiming
screen as shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show the cen-
ter of headlights.
9/24/04, 11:44 AM
SPECIFICATIONS:
"H";
Horizontal center line of headlights from
ground : 25.8 in. (656 mm)
"W";
Distance between each headlight center :
42.4 in. (1,078 mm)
"L";
Distance between the headlights and the
wall that the lights are tested against:
118 in. (3,000 mm).