Advertisement
3. Install the Pedals
STEP 3:
The pedals are stamped on the threaded end of the
axle with the letter "R" and "L" for Right and Left
respectively. Right and Left sides are determined as
you would use the indoor cycle. Install the Right
pedal on the Right crank arm using a 15 mm wrench.
Install the Left pedal on the Left crank arm using a 15
mm wrench. NOTE: The Left pedal is reverse
thread (you must turn it counter-clockwise to
tighten it).
4. Install the Handle Bar
STEP 4:
Remove set screw (19), slide the Handle bar
assembly (10) on to the handle bar stem.
Tighten the adjustment knob (17) after positioning
the handle bar. Install set screw (19) as shown
to the right.
Step 3
9
Advertisement
