Hitachi C 10FCH2 Handling Instructions Manual page 6

Line
Warning sign
CAUTION
It is dangerous to remove or install the workpiece
while the saw blade is turning.
When sawing, clean off the shavings from the turntable.
If the shavings accumulate too much, the saw blade
from the cutting material will be exposed. Never
subject your hand or anything else to go near the
exposed blade.
1. Tightly secure the material by vise assembly to be
cut so that it does not move during cutting
2. Switch operation
Pulling the trigger turns the switch on. Releasing the
trigger turns the switch off.
3. Holder (B), clamp lever adjustment: (Fig. 6)
Attach the included holder (B) in the position as shown
in Fig. 6 and adjust the holder (B) until its bottom
surface contacts the work bench surface. After
adjustments, securely tighten the 6mm bolt with the
included 10mm box wrench. Loosen the M6 × 20 screw
on the clamp lever and attach to a position where the
clamp lever can be easily operated.
M6 × 20 Screw
Clamp lever
6mm Bolt
Holder (B)
Adjust the holder
until its bottom
surface contacts the
work bench surface.
6
Line
Fig. 5
Move
Fig. 6
4. Using the Vise Assembly (Standard accessory) (Fig. 7)
(1) The vise assembly can be mounted on either the left
fence {Fence (B)} or the right fence {Fence (A)} by
loosening the 6 mm wing bolt (A).
6 mm Wing Bolt (B)
Fence (B)
Vise Shaft
6 mm Wing Bolt (A)
(2) The screw holder can be raised or lowered according
to the height of the workpiece by loosening the 6 mm
wing bolt (B). After the adjustment, firmly tighten the
6 mm wing bolt (B) and fix the screw holder.
(3) Turn the upper knob and securely fix the workpiece
in position.
WARNING
Always firmly clamp or vise to secure the workpiece
to the fence; otherwise the workpiece might be thrust
from the table and cause bodily harm.
CAUTION
Always confirm that the motor head does not contact
the vise assembly when it is lowered for cutting. If
there is any danger that it may do so, loosen the 6
mm wing bolt and move the vise assembly to a
position where it will not contact the saw blade.
5. Install the sub fence (B) (Fig. 8)
In the case of direct angle cutting and angle cutting,
use the sub fence. The sub fence (B) can be installed
on the right side of the guide fence (B). Place the
attached plate (A) in the position as shown in Fig. 8,
insert the tip in the groove of fence (B) and
simultaneously, insert flathead screw M6 into fence
(B), sub fence (B), and plate (A), then tighten nylon
nut M6 with the included 10mm box wrench until the
sub fence (B) can smoothly rotate. Then, you can
realize stable cutting of the material with a wide back
face.
Plate (A)
Sub fence (B)
M6 Nylon nut
Fence (B)
Screw Holder
Knob
Vise Plate
Workpiece
Fig. 7
M6 Flat screw
Fig. 8