Table of Contents
Advertisement
f.
Secure both plates with the screws provided. (Fig. 3d)
g.
Conversion is complete after both plates are secured. (Fig. 3e)
h.
Feed the wires coming out of the unit through the bottom of the cabinet.
i.
Lift the unit up flesh against the wall and the bottom of the cabinet.
j.
Using the screws and washers provided, insert into each of the 4 keyhole
openings (2 on each side) and tightly secure the unit against the bottom
of the cabinet.
NOTE: Install more screws through the back of the unit if necessary
k.
Connect 3-1/4" x 10" rectangular ducting to the collar of the hood.
l.
Finish off by sealing the connection point with aluminum tape.
INSTALLTION
Fig. 3d
Fig. 3e
9
Advertisement
Table of Contents
