Timer Operation - AirStage UTY-LNH series Operating Manual

TIMER OPERATION

Before using the timer function, be sure that the Remote Control Unit is set to the correct current time (☞ P. 4).
To Use the ON timer or OFF timer
1
Press the "START/STOP" button
(If the unit is already operating, proceed to step 2).
The receiver unit control panel's OPERATION Indicator Lamp (green) will
light.
2
Press the "TIMER MODE" button to select the OFF timer
or ON timer operation.
Each time the button is pressed the timer function changes in the following
order:
PROGRAM (OFF → ON, OFF ← ON)
The receiver unit control panel's TIMER Indicator Lamp (orange) will light.
3
Use the "TIMER
desired OFF time or ON time.
Set the time while the time display is fl ashing (the fl ashing will continue for
about 5 seconds).
button: Press to advance the time.
button: Press to reverse the time.
About 5 seconds later, the entire display will reappear.
To Use the Program timer
1
Press the "START/STOP" button
(If the unit is already operating, proceed to step 2).
The receiver unit control panel's OPERATION Indicator Lamp (green) will
light.
2
Set the desired times for OFF timer and ON timer.
See the section "To Use the ON timer or OFF timer" to set the desired mode
and times.
About 5 seconds later, the entire display will reappear.
The receiver unit control panel's TIMER Indicator Lamp (orange) will light.
3
Press the "TIMER MODE" button to select the PRO-
GRAM timer operation (OFF
display).
The display will alternately show "OFF timer" and "ON timer", then change to
show the time setting for the operation to occur fi rst.
The program timer will begin operation. (If the ON timer has been selected
●
to operate fi rst, the unit will stop operating at this point.)
About 5 seconds later, the entire display will reappear.
About the Program timer
The program timer allows you to integrate OFF timer and ON timer operations in a
●
single sequence. The sequence can involve 1 transition from OFF timer to ON timer,
or from ON timer to OFF timer, within a 24 hour period.
The fi rst timer function to operate will be the 1 set nearest to the current time. The
●
order of operation is indicated by the arrow in the Remote Control Unit's Display (OFF
→ ON, or OFF ← ON).
One example of Program timer use might be to have the air conditioner automatically
●
stop (OFF timer) after you go to sleep, then start (ON timer) automatically in the morn-
ing before you arise.
En-7
CANCEL OFF
/ TIMER
ON
" button to adjust the
ON or OFF ON will
To Cancel the Timer
Use the "TIMER MODE" button to select
"CANCEL".
The air conditioner will return to normal
operation.
To Change the Timer Settings
Perform steps 2 and 3.
To Stop Air Conditioner Operation while
the Timer is Operating
Press the "START/STOP" button.
To Change Operating Conditions
If you wish to change operating conditions
(Mode, Fan Speed, Temperature Setting), after
making the timer setting wait until the entire
display reappears, then press the appropri-
ate buttons to change the operating condition
desired.
To Cancel the Timer
Use the "TIMER MODE" button to select
"CANCEL".
The air conditioner will return to normal
operation.
To Change the Timer Settings
1. Follow the instructions given in the section
"To Use the ON Timer or OFF Timer" to
select the timer setting you wish to change.
2. Press the "TIMER MODE" button to select
either OFF ON or OFF
To Stop Air Conditioner Operation while
the Timer is Operating
Press the "START/STOP" button.
To Change Operating Conditions
If you wish to change operating conditions
(Mode, Fan Speed, Temperature Setting), after
making the timer setting wait until the entire
display reappears, then press the appropri-
ate buttons to change the operating condition
desired.
ON.