AirStage UTY-LNH series Operating Manual page 6

OPERATION
To Select Mode Operation
1
Press the "START/STOP" button.
The receiver unit control panel's OPERATION Indicator Lamp (green) will
light.
The air conditioner will start operating.
2
Press the "MODE" button to select the desired mode.
Each time the button is pressed, the mode will change in the following order.
AUTO
HEAT
About 3 seconds later, the entire display will reappear.
*1 "AUTO" can be set only in the indoor unit assigned to the representative
indoor unit.
*2 "FAN" cannot set to heat pump type.
To Set the Room temperature
Press the " SET TEMP. / SET TEMP.
button: Press to raise the temperature setting.
button: Press to lower the temperature setting.
● Temperature setting range:
AUTO ....................................18-30 °C
Heating ..................................16-30 °C
Cooling/Dry ...........................18-30 °C
The temperature setting cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the Remote Control Unit's Display).
About 3 seconds later, the entire display will reappear.
The temperature setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the "FAN" button.
Each time the button is pressed, the fan speed changes in the following order:
AUTO HIGH
About 3 seconds later, the entire display will reappear.
When set to AUTO:
Heating: Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the temperature of the
air issued from the indoor unit is low.
Cooling: As the room temperature approaches that of the temperature setting, the fan
speed becomes slower.
Fan: The fan runs at the low fan speed.
The fan will operate at a very low setting during Monitor operation and at the start of the
Heating mode.
En-5
COOL DRY
*1
FAN
*2
" button.
MED LOW
Example: When set to COOL.
Example: When set to 26 °C.
Example: When set to AUTO.