Table of Contents
Advertisement
Problem
Label files saved
previously are now empty.
Error Message List
Error Message
1 BLOCK LIMIT!
7 LINE LIMIT!
50 LINE LIMIT
REACHED!
BAR CODE
TOO LONG!
76
Cause
Have the batteries and AC adapter
been disconnected?
Is there enough power remaining in
the batteries?
Have you used the Reset function?
Cause
• This message appears if you
try to use the Numbering
function when multiple
blocks of text have been
entered with the PANEL1
Label Type mode selected.
• This message appears if 7
lines have already been
entered in a text block when
n
you press
• This message appears if you
delete
, causing the
number of lines in a block to
exceed the 7-line limit.
• This message appears if 50
lines have already been
entered when you press
g
n
, then
• The message appears if the
length of the bar code is
longer than 8.8" (22 cm)
when pressing p.
All files stored in the internal
memory are lost if the batteries and
AC adapter are disconnected for
longer than two minutes.
All data stored in the internal
memory is lost if the batteries
become empty or the AC adapter is
disconnected.
The resetting function clears all
data stored in the internal memory,
including label files.
• Cancel the Numbering
function.
• Limit the number of text
blocks to 1.
• Limit the number of lines in
a text block to 7.
.
• Adjust the number of lines
so that the block will not
have more than 7 lines.
• Limit the number of lines to
50.
.
• Reduce the width of the bar
code.
Solution
Solution
Advertisement
Table of Contents
