When An Error Message Appears On The Display - Brother P-Touch PT-D600 User Manual

Problem
Label files saved
previously are now
empty.
A tape jam which
cannot be cleared
keeps occurring.
I do not know the
version number of
the firmware for the
P-touch labeler.

When an error message appears on the display

When an error message appears on the display, follow the directions
provided below.
Message
Check # of digits
entered
Cutter Malfunction! The tape cutter has been closed when you tried to print or
Label Too Long!
Text Too Long!
Unable to use XX!
• All files saved in the internal memory are deleted if the
batteries are weak or the AC adapter was disconnected.
• Please contact Brother customer service:
1-877-BROTHER (877-276-8437)
• The version number and other information for the
firmware can be confirmed by pressing the following
keys:
1. Press ( ).
2. Select [Settings] using
or ( ).
3. Select [Version information] using
press ( ) or (
The number of digits entered in the bar code data does
not match the number of digits set in the bar code
parameters. Enter the correct number of digits.
feed tape. Turn the P-touch labeler off and then on again
before continuing. When tape is tangled in the cutter,
remove the tape.
The length of the label to be printed using the text entered
is longer than 39.37" (1 m). Edit the text so that the length
of the label is less than 39.37" (1 m).
The length of the label to be printed using the text entered
is longer than the length setting. Edit the text to fit within
the set length or change the length setting.
Please contact Brother customer service.
TROUBLESHOOTING
Solution
or , and then press (
).
Cause/Remedy
When an error message appears on the display
)
or , and then
52