Table of Contents
Advertisement
When an error message appears on the display
When an error message appears on the display, follow the directions
provided below.
Message
Check # of Digits
Entered!
Cutter Error!
Length Limit!
Text Too High!
Text
Too Long!
System Error XX
1.800.561.8187
The number of digits entered in the bar code data does
not match the number of digits set in the bar code
parameters. Enter the correct number of digits.
The tape cutter has been closed when you tried to print or
feed tape. Turn the P-touch labeler off and then on again
before continuing. When tape is tangled in the cutter,
remove the tape.
The length of the label to be printed using the text entered
is longer than 1 m. Edit the text so that the length of the
label is less than 1 m.
The text size is too large.
The length of the label to be printed using the text entered
is longer than the length setting. Edit the text to fit within
the set length or change the length setting.
Please contact Brother customer service.
www.
.com
TROUBLESHOOTING
Cause/Remedy
When an error message appears on the display
information@itm.com
29
Advertisement
Table of Contents
