Table of Contents
Advertisement
Adding a new line of text
To end the current line of text and start a new one, press n. "
the end of the line.
The number of text lines that can be printed depends on the width of the tape.
The line number on the display indicates the line number of the text block.
Adding a new text block
To create a new text block so that one section of the text can have a different
number of lines than another, press g, then n. "
the block.
For example, text entered as shown below, will be printed as follows.
R
2:456
R
1:ABC_
----
-- 1
A single label can only contain a maximum of fifty text blocks.
The number of the block that the cursor is in is indicated at the bottom of the display.
All text blocks have the same formatting features.
While trying to print a large amount of data at one time, some outputted labels may be
blank. For example, when printing 50 records, the maximum number of characters
that can be printed at one time is limited to approximately 200.
Inserting text
To insert the text that you type at the cursor's current position, make sure that the
Insert indicator is displayed. Otherwise, press i to enter Insert mode.
To replace the text at the cursor's current position instead of inserting it, press i
to exit Insert mode.
Tape Width
1/4" (6 mm)
3/8" (9 mm)
1/2" (12 mm)
3/4" (18 mm)
1" (24 mm)
NORMAL 2
Maximum Number of
Lines That Can Be Printed
2
2
3
5
7
" appears at
" appears at the end of
21
Advertisement
Table of Contents
