Projecting; Selecting The Input Signal; How To Adjust The State Of The Image - Panasonic PT-CW33OE Operating Instructions Manual

Projecting

Check the connections of the peripheral devices and connection of the power cord (
power ( page 30) to start the projector. Select the image and adjust the state of the image.
Æ

Selecting the input signal

Select an input signal.
Press <INPUT> button on the control panel or the <INPUT>, <COMPUTER>, <HDMI>,
<VIDEO>, <S-VIDEO> on the remote control.
The image of the signal being input in the selected terminal is
z
projected.
Press <INPUT> button to display the [Source] menu. Press
z
▲▼ to select the desired input and press ► to enter.

How to adjust the state of the image

1 ) Adjust the projection angle.
Place the projector parallel to the screen, and then install it on a flat surface so that the screen becomes
z
rectangle.
If the image is tilted lower than the screen, extend the adjustable feet to make a rectangle screen.
z
For details, see "Adjusting the Projector's Height" (
z
2 ) Adjust the focus.
Turn "Focus Ring" to adjust the image.
Note
It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
z
If keystone distortion occurs, see [V Keystone] in the [Position] menu (
z
page 24).
Æ
Focus Ring
page 28) and switch on the
Æ
Æ page 39).
Projecting
31
ENGLISH -