Table of Contents
Advertisement
Test Pattern
Use this function to display built-in test pattern when
installing the projector.
1 )
Press ▲▼ to select [Test Pattern].
2 )
Press ► to display the setting dialog
box.
3 )
Press ◄► to switch [On]/[Off].
If you want to return the normal mode to the
z
previous image, set [Test Pattern] to [Off] in the
[Setting] menu.
On
Display the built-in Test Pattern.
Off
Disable the function.
Remote ID
When you use the system with multiple projectors,
you can operate all the projectors simultaneously or
each projector individually using single remote control,
if a unique ID number is assigned to each projector.
There are 7 different remote control IDs: [All],
[ID1]~[ID6].
1 )
Press ▲▼ to select [Remote ID].
2 )
Press ► to display the setting dialog
box.
3 )
Press ◄► to select the desired item.
Attention
When operating the projector under [All] code, you can
z
operate several projectors at the same time.
If you want to control the projector with a specified
z
remote control ID, make sure the remote control ID on
the remote control fit to the remote control ID on the
Æ
projector. (
page 19)
Startup Logo
Set this function to display the Panasonic logo when
the projector is turning on.
1 )
Press ▲▼ to select [Startup Logo].
2 )
Press ► to display the setting dialog
box.
3 )
Press ◄► to switch [On]/[Off].
The logo will display when the
On
projector is turning on.
The logo will not display when the
Off
projector is turning on.
Reset
Return all data that has been set in the menu to the
factory defaults.
1 )
Press ▲▼ to select [Reset].
2 )
Press ► to display the setting dialog
box.
3 )
Press ▲▼ to select Yes.
4 )
Press ► to execute.
Note
Lamp used time has been set by user in the [Security]
z
menu will not be reset.
Setting
41
ENGLISH -
Advertisement
Table of Contents
