Reduced Spin Speeds; No Spin; Spin Speed Adjustment; Reduced Times (Quick) - Electrolux Washer Service Manual

7.3.15

Reduced spin speeds

The speed during all spin phases is lowered, as shown on the table:
Maximum spin speed (RPM)
Reduced speed for COTTON (RPM)
Reduced speed for OTHER CYCLES
(RPM)
7.3.16

No spin

All spin phases are eliminated
Three rinses are added to the COTTON cycle and one rinse is added to the SYNTHETICS cycle
7.3.17

Spin speed adjustment

The speed of all spin phases in the cycle is reduced
The last selected position can be used for NO SPIN and RINSE HOLD (stop with water in the drum)
NO SPIN adds three rinses to the COTTON cycle and one rinse to the SYNTHETICS cycle

7.3.18 Reduced times (Quick)

The COTTON – SYNTHETICS – DELICATE FABRICS programmes are modified to obtain very short
time wash times (optimized for small, lightly soiled loads)
The number of rinses is reduced (one less rinse)
The water level in the other two rinses is increased
When this option is selected, machine configuration is the same as in the SHORT – VERY SHORT
programmes
7.3.19

Temperature adjustment

Allows the wash temperature to be adjusted up to the max. temperature allowed for the cycle.
Available during cycle selection; temperature can be adjusted (with machine in the pause mode) only if
the heating phase has not yet begun.
7.3.20

Delayed start time

•
Models with digital display
When the programme is chosen, a delayed start ranging from 30 minutes to 23 hrs can be selected (
30' 60' 90' 2hrs
During the delay period, the time decreases an hour at a time until 2hrs remain, then the decrease is
30 minutes at a time.
To start the cycle immediately, after the delay time has been started, press the Start/Pause button,
cancel the delay time by pressing the relative button, and press Start/Pause once again.
•
Models with LEDs
A pause is included before the programme begins. The delay time is indicated by the corresponding
LEDs.
To start the cycle after the delay time has been started, press the Start/Pause button, cancel the delay
time by pressing the relative button, and press Start/Pause once again.
7.3.21

Disabling the buzzer

For models featuring a buzzer, this device can be
disabled, in which case it will not sound during
cycle selection or at the end of the cycle, though it
remains enabled in the event of an alarm.
To disable the buzzer, press buttons 1 and 2 at
the same time for two seconds. The buzzer will
remain disabled until the same procedure is
repeated.
SOI/DT 2005-01dmm
600 700 800 900 1000 1100 1200 1300 1400 1500 1600
450 450 450 450 500 550 600 650 700 750 800
450 450 450 450 450 450 450 450 450 450 450
3hrs... 23hrs 0hrs).
15/65 599 36 82 56