5.3.9
Sensitive
Adds a rinse in the COTTON – SYNTHETIC FABRICS.
During the cotton cycles the movements pass from vigorous to normal.
Eliminates the intermediate spins except from the last two which are reduced.
5.3.10 Extra rinse
Adds two rinses in the COTTON, SYNTHETICS and DELICATES cycles.
Eliminates the intermediate spin cycles, with the exception of the last rinse, which is reduced to 450 rpm.
If the appliance features this button press it and then the corresponding LED lights.
5.3.11 "Half load" button
Eliminates a rinse in the COTTON programmes.
5.3.12 Easy-Iron
•
In COTTON programmes:
Adds three rinses.
Eliminates the intermediate spins.
Performs an impulse spin phase.
Adds an "untangling" phase after the spin cycle.
•
In SYNTHETICS cycles:
Reduces the heating temperature in 50/60° cycles to 40°C.
Increases the washing time.
Prolongs the cooling phase at the end of the washing phase.
Adds one rinse without spin cycle.
Adds an "untangling" phase after the impulse spin cycle.
5.3.13 Reduced spin speed
Reduces the speed of all spins as shown in the table.
Maximum spin speed (rpm)
Reduction for COTTON (rpm)
Reduction for ALL OTHER CYCLES
(rpm)
5.3.14 No spin
Eliminates all the spin phases.
If selected, three rinses are added in the COTTON cycle and one in the SYNTHETICS cycle.
5.3.15 Modifying the spin speed
Reduces the speed of all spin cycles.
The last position can be used for NO SPIN, RINSE-HOLD.
If the NO-SPIN option is selected, three rinses are added in the COTTON cycle, and one in the
SYNTHETICS cycle.
5.3.16 Time reduction (Quick)
Modifies the structure of the COTTON - SYNTHETICS– DELICATES programmes to obtain washing
time very short (optimization for small or lightly-soiled loads).
Reduces the no. of rinses (one rinse less).
Increases the water level of the other two rinses.
Corresponds to the SHORT- VERY SHORT cycles on the basis of the configuration of the appliance.
5.3.17 Temperature adjustment
Used to select the washing temperature compatibly with the limit temperature for the cycle.
Can be used during the cycle selection phase: the temperature can be modified only if the heating phase
has not started (in pause mode).
SOI/DT 2006-11 dmm
600 700 800 900 1000 1100 1200 1300 1400 1500 1600
450 450 450 450 500 550 600 650 700 750 800
450 450 450 450 450 450 450 450 450 450 450
12/39
599 38 47 87