Table of Contents
Advertisement
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
Check screws and nuts
Check for fuel and oil leakage
Clean the air filter's pre-filter (foam plastic)
Check the V-belts
1)
Change the engine oil
Lubricate joints and shafts
Replace the air filter's pre-filter and paper filter
Replace the plugs
Clean the engine's and the hydrostat's cooling flanges
Check the valve clearance
Check the valves and seats
1)
2)
First change after 8 hours.
machine lubrication should be conducted twice a week.
= Described in these instructions.
= Not described in these instructions.
!
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
•
The engine is switched off.
•
The ignition key is removed.
•
The ignition cables are removed from the plugs.
MAINTENANCE
Maintenance schedule
2)
3)
2)
4)
4)
During dusty conditions cleaning and replacement should be more frequent.
4)
Conducted by authorised service workshop.
Daily
main-
Page
before start
19
19
19
20
20
21
22
22
-
-
23
24
37
22
-
35
36
37
23
37
38
-
2,4)
-
-
-
•
The parking brake is applied.
•
The cutting unit is disengaged.
Maintenance interval
in hours
100
25
50
300
3)
For daily use of the
English -
17
- Quick Links:
- Cutting Unit
- Wiring Diagram
- Technical Data
Hide quick links:
Advertisement
Chapters
Table of Contents
