Switching On; Using The Remote Control; Using The Controls On The Tv - Toshiba 40L53** DIGITAL Series Owner's Manual

Switching On

If the RED Standby LED is unlit, check that the plug is connected to the power supply. If the picture
does not appear press on the remote control, it may take a few moments.
To put the television into Standby press on the remote control. To view the television press
again. The picture may take a few seconds to appear.
For energy saving:
We recommend that you use the television with factory settings. These settings are designed for
energy saving. Unplugging the mains plug will reduce energy use to zero. This is recommended
when the television is not being used for long periods, e.g. when on holiday. Reducing the bright-
save money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce energy consumption, but will still draw
some power.

Using the Remote Control

To set up the television you will now need to use the on screen menus. Press MENU on the remote
control to see the menus.
on the navigation ring on the remote control.
To use the options, press
move up and down through the menu and use to select the required choice. Follow the on-
screen instructions. The functions of each menu are described in detail throughout this manual.

Using the Controls on the TV

Press to adjust volume.
Press to change programme selection, then press to adjust programme selection.
Press and hold until Source List is displayed, then press to scroll through the list until
desired input source is located.
lease alwa s refer to the owner s manual of the e uipment to be connected for full details
NOTE: Inserting the headphone plug will mute the sound from all speakers.
19