Inserting The Batteries Into The Remote; Switching On The Tv - Toshiba UA3D63DA Quick Start Manual

1

Inserting the batteries into the remote

The remote may have a screw that secures the battery compartment cover onto the remote control (or this
may be in a separate bag). Remove the screw, if the cover is screwed on previously. Then remove the battery
compartment cover to reveal the battery compartment. Insert two 1.5V size AAA batteries. Make sure the (+)
and (-) signs match (observing correct polarity). Do not mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. Secure the cover again with the screw, if any.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
rear side of the TV
rear-left side of the TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cord to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
3

Switching on the TV

In order to turn the TV on from standby mode:
• Press the Standby button on the remote control
• Press the control button on the TV
satellite
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control.
HDMI connection
rear side or rear-left
side of TV
English - 1 -