Control Lock Mode Operation - NEC MULTISYNC LCD1800TM User Manual

Group
Item
Icon
Icon
OSD POSITION
CLAMP PULSE POSITION
5.2

CONTROL LOCK Mode Operation

1. Press the right of select button and minus of adjust
button together, the "CONTROL LOCK" screen ap-
pears.
SELECT
ADJUST
2. Press the plus button to lock on the OSM
the Locked condition, "Key mark
on the upper-right of the OSM screen and "BRIGHT-
NESS" is only adjustable.
A/B signal change and OSD OFF by front SW are
functionable.
Press "ALL RESET" to restore to the factory preset level.
Press and
Set data by each timing.
Set data does not change by the changing of the signal timing.
Press the Minus Button:
Item
ALL RESET
To move the OSD position for 5 places.
To select the constant
POWER SAVE
power mode.
To off the Auto Adjust-
AUTO SELECT
ment Function.
To eliminate an excessive green or white-back
ground that may occur when both Sync-On-Green
and external sync signals are applied to the moni-
tor.
To clamp the video sig-
nal at the front of the H-
Sync pulse.
To choose the language used on OSM.
ENG...English, DEU...German, ESP...Spanish,
LANGUAGE
FRA...French, ITA...Italian, JPN...Japanese
TM . During
" is indicated
buttons together, to restore to the factory preset level.
Press the Plus Button:
To restore to the fac-
tory preset mode.
To select the power
save mode.
To on the Auto Select
Function.
To clamp the video sig-
nal at the back of the H-
Sync pulse. If you con-
n e c t t o a n o l d e r
Macintosh, you may
need to press plus but-
ton.
ADJUST
+
-
3. Press the minus button to lock off the OSM, and if you
press any select or adjust button, Key mark
disappeared from the OSD screen. You can operate
OSM, again.
ADJUST
- +
- 1-11 -
is