Connect Cable And Attach On Windshield; Connect To Power Source To Turn On The Unit - VisionDrive Black Box VD-9000FHD User Manual

Installation Procedure

3. Connect cable and attach on windshield

The adhesive on the bracket is very strong so partially remove the cover of the adhesive,
Use the full adhesive surface area for final installation after correct installation is verified
through LCD screen.
Please proceed cigarette lighter connection after the main cable connection and
attachment are finished.

4. Connect to power source to turn on the unit

Clean the area on the windshield where the
unit will be placed.
For the placement of the unit, it is better to
place the unit closer to the center of the
vehicle. If the unit is installed on the left or
right side of the rear vision mirror, make sure
there is room to detach and install the unit if
needed. Also be aware of window tinting or
other window coatings/shielding which may
affect camera visibility.
Insert the cigarette jack into an appropriate
outlet.
Turn on the engine or put the car key at ACC
to hear voice notification while the product
starts. (LCD screen will be turned on at this
moment)
Blinking of LED lamps after a moment means
that the system startup was successful.
DO NOT turn off the power source while the
system boot is in progress. This may harm the
product.
11
visiondrive.co.kr