Enabling The Automatic Start Mode; Section 5. Cleaning And Maintenance; Cleaning The Filter Canister - Polaris 9300xi Sport Owner's Manual

Remote control of the Polaris 9300xi Sport is available
using the hand held remote control unit.
The remote control unit has four (4) buttons:
Rotate Left
Forward
Figure 20. Remote Control
To turn the cleaner, you must hold down the rotate left
or rotate right button.
When using the remote control unit, the two (2) lights on
the control unit
To return to automatic mode, either stop using the re-
mote control unit buttons for a minimum of 45 seconds
or press Cycle I or Cycle II button on the control unit.

4.5 Enabling the Automatic Start Mode

This Automatic Start Mode allows the control unit to
launch a pre-selected cleaning cycle triggered by an
external source (timer / programming clock).
The cycle can be either "Cycle I" or "Cycle II".
The 9300xi Sport will run for 2.5 hours.
It is not possible to change the running time when
operating in this mode.
Procedure for launching a cycle with
a programming clock (timer):
1. Connect the control unit to the receptacle.
2. To automatically start the "Cycle I", press the
following button for more than three (3) seconds:
+ Cycle I
3. To automatically start the "Cycle II", press the
following button for more than three (3) seconds:
+ Cycle II
4. The two (2) lights will fl ash once
5. The robot will start automatically when it is
powered on.
Rotate Right
Reverse
will fl ash alternately.
Procedure for cancelling an automatic start:
1. Connect the control unit to the receptacle.
2. Press the OFF button for more than six (6) seconds.
3. The two (2) lights will fl ash once

Section 5. Cleaning and Maintenance

WARNING
To avoid electric shock and other hazards which
could result in permanent injury or death, disconnect
(unplug) the cleaner from the control unit before
performing any cleaning and maintenance.

5.1 Cleaning the Filter Canister

The fi lter canister should be cleaned at the end of each
cycle.
1. Ensure that the control unit cable has been
disconnected from the electrical outlet or that the
fl oating cable has been disconnected from the
control unit.
2. Remove the cleaner from the water and let the
remaining water drain by maintaining the cleaner
in the vertical position.
3. Set the unit on its wheels.
4. To remove the fi lter from the cleaner, follow the
steps 1 through 6 (Figures 21 through 24).
5. Push the cover lock (1) and lift the cover (2) until
it is secured in the vertical position. Refer to
Figure 21.
1
2
Figure 21. Lift Cleaner Cover
6. Remove the fi lter assembly from the body (3), as
shown in Figure 22.
7. Push the quick release button on the canister
assembly (4) and pull open the fi lter assembly (5).
Refer to Figure 23.
8. Separate the fi lter canister from the fi lter support
(6), as shown in Figure 24.
9. Wash the fi lter canister, the fi lter support, and the
cleaner under water or using a hose (7). Refer to
Figure 25.
Page 11