Installation - Sanyo VDC-D1184VA Instruction Manual

INSTALLATION

(Model VDC-D1184VA)
(E)
(F)
(D)
(C)
(A)
(G)
(B)
(Model VDC-D2184VA)
73mm
(F) (E)
(D)
(C)
(H)
(I)
Note: When setting up this camera, make sure that it is installed
securely. If it is not installed correctly, it may fall down. In
addition, do not touch the camera in places except where
settings and adjustments are necessary.
Installing the Model VDC-D1184VA
1
Use the supplied hexagonal wrench to remove the four fixing
screws (B) of dome cover (A).
2
Make screw holes and a cable hole in the cushioning sheet (D)
that attaches to the back of the camera unit (C).
3
Attach the cushioning sheet (double-sided tape) to the back of the
camera unit.
4
Align the camera unit with the surface of the ceiling, make marks
on the ceiling in the places where the screw holes are to be
drilled, and then drill the four holes.
5
Cut a hole in the ceiling for routing the cables.
Note: If not routing the cables inside the ceiling, pass the cables
through the conduit hole.
The following step differs only when installing the Model
VDC-D2184VA
Make a cable hole with a diameter of 73 mm.
4
English