Setting Up Lomlite2 Privileges For Named Users; Permissions Available For Lomlite2 Users - Sun Microsystems Netra T4 AC100 Installation And User Manual

Setting Up LOMlite2 Privileges for
Named Users
You can specify up to four named users of the LOMlite2 device on a Netra T4 server.
By default, no users are set up and therefore no user login prompt appears when
you use the LOM escape sequence.
However, if you set up one or more users, each time you use the LOM escape
sequence to display the lom> prompt you are prompted for a user name and
password. Therefore, one of the user accounts you set up, must be for yourself.
Four areas of authorization are available for named users. By default, all four are
open to them. However, if you specify any (using the lom> userperm command),
only those that you specify will be available.

Permissions Available for LOMlite2 Users

The four areas of authorization available by default are:
Console permission (c-level)
This enables the named user to exit from the lom> prompt to the Solaris prompt
(if the LOM console port is shared between the LOMlite2 and the console).
User administration permission (u-level)
This enables the named user to add and delete users and alter their permissions.
Administration permission (a-level)
This enables the named user to change the LOMlite2 device's configuration
variables (see "Introducing Lights Out Management" on page 91).
Reset permission (r-level)
This enables the user you have named to reset the server and to power it on and
off using the LOMlite2 device.
For information about how to specify one or more of these areas of authorization for
a named user, see "Specifying Permissions for a Named User" on page 105.
102 Netra T4 AC100/DC100 Installation and User's Guide • August 2001