Table of Contents
Advertisement
PRE-INSTALLATION
CONFIGURATION INSTALLATION
Part 1
•
Remove front glass door by removing the cardboard fillers at the top and lifting up and away from
the appliance.
•
Install the handles onto the door using screws from the handle package.
•
Keep front glass door off of the appliance until installation of Configuration Kit and Control Kit are
completed.
•
Remove carton containing logs. Retain for later installation.
•
Remove and dispose of the cardboard support for log carton.
•
Remove burner pan by removing two (2) screws. Replace screws in holes for later use.
•
Remove the hearth pan that burner was secured to by lifting up and off of its four (4) locating pins.
Part 2
The appliance is now ready for one of the following Configuration Kits:
Bay Kit
Corner Kit (left or right)
Island Kit
Peninsula Kit
See-thru Kit
Complete installation instructions are included with each kit.
Part 3
After installing the Configuration Kit, the appliance is ready for one of the following Control Kits:
Control Kit Natural Gas Standing Pilot
Control Kit Propane/LP Gas Standing Pilot
Control Kit Natural Gas Electronic Ignition
Complete installation instructions are included with each kit.
•
Once your Configuration Kit and Control Kits have been installed, install the hearth pan by position-
ing it down onto the four (4) locating pins. Make sure the access panel is positioned over the con-
trols.
•
The burner may now be installed onto the hearth pan. This is done by positioning the large opening
in the burner, over the pilot protruding up from the control panel. Lower the burner around the pilot
down onto the firebox bottom.
•
Looking through the large opening in the burner pan, position the burner tube with the air shutter
onto the orifice mounted on the control panel.
•
The burner may now be secured at both ends with screws removed earlier.
Proceed with installation.
53D9009
6BK
6CK
6IK
6PNK
6SK
6CN
6CLP
6CEN
B-Vent Specialty Gas Fireplaces
7
Advertisement
Table of Contents
