Table of Contents
Advertisement
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS FOR UNITS WITH 6CN/6CLP CONTROLS
When lighting and relighting, the gas knob cannot be turned from pilot to OFF unless the knob
is depressed.
1. STOP! Read the safety information on Page 19.
2. Turn off all electric power to the appliance.
3. Turn gas control knob clockwise
4. Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell
gas STOP! Follow "B" - What to Do if You Smell Gas. If you do not smell gas, go to the next
step.
5. If appliance is equipped with HI-LO adjustment valve, turn counterclockwise
HIGH.
6. Find pilot located in front of the middle log.
7. Turn gas knob counterclockwise
8. Depress and hold gas knob while lighting the pilot with the push button ignitor. Keep knob
fully depressed for one minute, then release. If pilot does not continue to burn, repeat steps
3 thru 7.
9. With pilot lit, turn gas knob counterclockwise
10. If equipped with remote ON/OFF switch, main burner may not come on when you turn the
valve to ON or HIGH. Remote switch must be in the ON position to ignite burner.
11. Turn on all electrical power to the appliance.
FP2213
1. Turn off all electrical power to the appliance if service is to be performed.
2. Push in the gas control knob slightly and turn clockwise
53D9009
to OFF.
to PILOT.
Gas Knob OFF
TO TURN OFF GAS
to ON.
Pilot
Thermocouple
FP2214
to OFF. Do not force.
B-Vent Specialty Gas Fireplaces
to
Generator
Piezo Electrode
23
Advertisement
Table of Contents
