Packet Data Access Points - Nokia 5230 User Manual

To change the priority of an access point within the group, select
Organise Change
>

Packet data access points

Select Menu Settings
>
follow the instructions on the screen.
To edit a packet data access point, open one of the access point groups, and select
an access point marked with
Follow the instructions from your service provider.
Select from the following:
Access point name
●
provider.
User name — The user name may be needed to make a data connection, and
●
is usually provided by your service provider.
Prompt password
●
a server, or if you do not want to save your password in the device, select Yes.
Password — A password may be needed to make a data connection and is
●
usually provided by your service provider.
Authentication
●
Normal to send your password encrypted when possible.
Homepage — Depending on the access point you are setting up, enter the web
●
address or the address of the multimedia message centre.
Use access point
●
confirmation before the connection using this access point is created, or
Automatically
access point automatically.
Select Options
>
Network type
●
your device. The other settings depend on the selected network type.
Phone IP address
●
120
priority.
and Connectivity
.
— You obtain the access point name from your service
— If you must enter the password every time you log in to
— Select Secure
— Select After confirmation
if you want the device to connect to the destination using this
Advanced settings
— Select the internet protocol type to transfer data to and from
(for IPv4 only) — Enter the IP address of your device.
Destinations
>
to always send your password encrypted or
if you want the device to ask for
and from the following:
© 2010 Nokia. All rights reserved.
Options
>
Access point, and
>