Swing; Group; A/F; Osd - Samsung SCC-1000 User Manual

Controlling PTZ Camera

7. SWING

■ The Swing function commands the camera to move between 2 selected locations,
monitoring the route.
Press the SWING button.
①
Press Number 1 or 2 to activate the Swing mode.
②
- Number 1 : Commands the camera to pan while moving between 2 locations.
- Number 2 : Commands the camera to tilt while moving between 2 locations.
• To pause Swing, move the joystick.

8. Group

■ The Group command recalls a ground of multiple preset locations in sequence.
Enter the group number.
①
Press the GROUP button to activate the Group mode.
②
• To pause the Group mode, move the joystick.
Notes
• In order to use Swing and Group modes, you must set up the modes in the camera's OSD menu
prior to actual operation.
• The Swing and Group modes only support the Samsung Techwin SPD protocol.

9. A/F

■ Pressing the A/F button uses One-Shot AF.
12
PTZ CONTROLLER User Guide
Controlling PTZ Camera

10. OSD

■ Shows the camera's OSD menu on the monitor screen.
To enter the OSD menu, press the OSD button. To exit the
①
menu, hold down the OSD button. (SPD Protocol)
ENT Button : Performs the Enter function in the OSD menu.
②
CLR Button : Performs the Esc function in the OSD menu.
③
To move the menu cursor upward, downward, leftward, or
④
rightward, use the joystick. Certain protocols (Panasonic,
Samsung Electronics, etc.) do not support using the joystick
to move the menu cursor. Instead, they require pressing a
number button while holding down the FN button. (Number
2, 4, 6, 8 Buttons)

11. Lock

■ Locks out the controller.
To lock out, hold down the LOCK button.
①
To unlock, enter the 4-digit password. (Default Password: 0000)
②

12. AUX

■ Controls the camera's Aux output operation.
AUX ON : Press the AUX button to turn AUX on.
①
AUX OFF : Hold down the AUX button for 2 seconds to turn AUX off.
②
PTZ CONTROLLER
13
User Guide