Troubleshooting - Bissell 7920 SERIES User Manual

Troubleshooting

WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
20
ug310-5815_7920E_604.indd 20 ug310-5815_7920E_604.indd 20
SmartTemp Ready Light does not illuminate.
Possible Causes
The machine Power Switch is not
turned ON.
Reduced spray or no spray
Possible Causes
Bladder may be empty.
SmartMix Bottle may be empty.
The Filter may be clogged.
Tanks may not be seated properly.
Pump may have lost prime.
The Pump Belt may be broken.
Lift Here
Insert
Screwdriver
Blade Here
Remedies
Switch must be ON to
activate the SmartTemp Ready Light.
Remedies
Refill bladder with hand hot tap water.
Fill with BISSELL Advanced Deep Cleaning
Formula for cleaning or water
if rinsing.
Clean out Flow Indicator Filter, page 17.
Turn Power Switch OFF; remove &
reseat tanks. Inspect for presence
of seals.
Turn Power Switch OFF; after 1 minute
turn ON and depress trigger.
Turn Power Switch OFF and unplug
from the outlet. To check if a Pump
Belt has broken, you will need a flat
head screwdriver. Insert the blade end
into the lower slot of the Belt Access
Door to release the lower snap. If
necessary, insert the blade end into
the upper slot to release the upper
snap. Examine the belt for breakage.
You should be able to see the Pump
Belt looped around the motor shaft. If
it is broken or missing, please refer to
Replacement Parts on page 23 before
calling Consumer Services. Complete
installation instructions will
accompany the Replacement Belt.
3/29/06 3:39:50 PM 3/29/06 3:39:50 PM