The Flow Indicator; Readytools Dial - Bissell 7920 SERIES User Manual

When It's Time to Empty Tank-in-Tank Continued
3.
4.
5.
6.
7.
8.
9.

The Flow Indicator

The Flow Indicator is located on the machine base. It spins when the
trigger is pressed to indicate that the machine is applying cleaning
solution to the floor. It will stop spinning to indicate that the SmartMix
Bottle or Bladder needs to be refilled, or when the trigger is released.

ReadyTools Dial

This provides above floor cleaning with the flip of a switch.
Just choose the cleaning tool or protector applicator, attach
to the Flex Hose and ProHeat Pro-Tech is ready to clean
upholstery, stairs or apply extra protection against dirt and
tough stains when using the Scotchgard protector applicator.*
ug310-5815_7920E_604.indd 9 ug310-5815_7920E_604.indd 9
Remove Tank Lid by rotating handle forward to unlatch
lid and lifting lid off tank.
Pour out dirty water.
After each use, remove and rinse the Lint Screen located
on the tank lid.
A. Remove Tank Assembly from unit.
B. Remove Tank Lid.
C. Remove any debris caught in Lint Screen.
D. Reinsert Lint Screen on Tank Lid. The screen will
click into place
E. Replace Tank Lid.
F. Reinsert Tank Assembly into unit.
Refill with clean hand hot tap water, following steps 5
through 9 on page 8, and refill the SmartMix Bottle with
BISSELL Advanced Deep Cleaning Formula as necessary.
When the cleaning job is complete, rinse out the
Tank-in-Tank by rinsing clean water between the Bladder
and Tank.
Return Tank-in-Tank to the machine, following steps 6
through 9 on page 8.
Refer to the Maintenance section on pages 17-19 for
the final cleanup.
Note: Flow Indicator does not spin when set to
Tools/PreTreat setting.
*Set the ReadyTools Dial to Floor Cleaning when
cleaning carpets or bare floors or set it to Tools/
PreTreat when using the Flex Hose attachments
or for pre-treating floors, or when applying the
Scotchgard protector applicator.
SmartTemp heats the cleaning solution for carpet
and bare floor application only. It does not heat
solution sprayed through the accessory tools.
Pour out
3
Rotate Handle to
4
dirty water
unlatch
5C Lint Screen
3
Fill bladder
8
only with clean
6
hot tap water
Tip:
A special red
float device
in the Tank will
cause the cl e aner
to stop removing
Tip:
solution from the
carpet and the
Thorough
motor sound will
vacuuming
rise in pitch to
before deep
let you know the
cleaning will
dirty water tank
prevent early
is full.
clogging of
Lint Screen.
Flow Indicator
ReadyTools Dial
5D
Latched
9
3/29/06 3:39:45 PM 3/29/06 3:39:45 PM