Connecting The Ipod; Using This Feature - RAM Truck 2011 Owner's Manual

This feature allows an iPod
vehicle's sound system through a 16–pin connector, using
the provided interface cable.
iPod control supports Mini, 4G, Photo, Nano, 5G iPod
and iPhone devices. Some iPod software versions may
not fully support the iPod control features. Please visit
Apple's website for software updates.
NOTE:
• If the radio has a USB port, refer to the appropriate
Uconnect Multimedia radio user's manual for iPod or
external USB device support capability.
• Connecting an iPod to the AUX port located in the
radio faceplate, plays media, but does not use the
iPod control feature to control the connected device.

Connecting The iPod

Use the provided connection cable to connect an iPod to
the vehicle's 16–pin connector port (which is located in
to be plugged into the
UNDERSTANDING YOUR INSTRUMENT PANEL 245
the glove compartment on some vehicles). Once the
iPod is connected and synchronized to the vehicle's
iPod control system (iPod may take a few seconds to
connect), the iPod starts charging and is ready for use
by pressing radio switches, as described below.
NOTE:
• It may be necessary to remove the connector pin
protection cap from the 16–pin connector port, prior to
connecting the cable.
• If the iPod battery is completely discharged, it may
not communicate with the iPod control system until
a minimum charge is attained. Leaving the iPod
connected to the iPod control system may charge it to
the required level.

Using This Feature

By using the provided connection cable to connect an
iPod to the vehicle's iPod control 16–pin connector
port:
4