D3.2 Display/Edit Mode Switching - Vigilantplant YFGW510 User Manual

D3.2 Display/Edit Mode Switching
The Setup Tool has two operation modes: Display, to view the setting information, and Edit, to
configure YFGW510. The Setup Tool always starts up in Display mode. To allow for YFGW510
configuration, the mode needs to be switched to Edit.
IMPORTANT
If YFGW510 is factory default, the setup tool starts in Edit mode.
Otherwise, the setup tool starts in Display mode and each field and button is grayed out.
IMPORTANT
If switching Display/Edit Mode, YFGW510 will restart.
IMPORTANT
In Edit mode, only infrared communication is available.
To change modes, select the [Maintenance] tab as shown in Figure D3-1.
Figure D3-1 Maintenance tab
Click the button in the [Display Mode/Edit Mode] field to select the target mode.
If the button shows "Edit Mode", a current mode is Display. Otherwise, a current mode is Edit.
Clicking the [Edit Mode] button displays a confirmation dialog as shown in Figure D3-2.
<D3. Configuration Method>
D3-2
FD0301.ai
IM 01W02E01-01EN