Safety Precautions; About Radio Wave - Vigilantplant YFGW510 User Manual

Field wireless access point
Hide thumbs Also See for YFGW510:
Table of Contents

Advertisement

Safety Precautions

IMPORTANT
Read the safety precautions for this product that are described in Read Me First (IM 01W02E01-
11EN).

About Radio Wave

IMPORTANT
Read the safety precautions for this product that are described in Read Me First (IM 01W02E01-
11EN).
IMPORTANT
• This product is equipped with a wireless module which is designated as a certification of
construction type as a wireless facility for 2.4 GHz band low-power data communication
system of the Radio Act.
Refer to G1.3 Regulatory Compliance Statements for detail.
Due to the designated certification of construction type, users may be subject to legal pun-
ishment in case of:
- Disassembling or modifying the wireless module or antenna in this instrument
- Peeling off the certification label attached to the wireless module in this instrument
• Microwave ovens and other industrial, scientific and medical equipment, as well as local
wireless stations (license required) and specific low-power wireless stations (license not
required) for identifying mobile objects used in the production line of a factory, use the same
frequency band as this product. Prevent interference with other wireless stations.
• Check that local wireless stations and specific low-power wireless stations are not being
used in the vicinity before using this product.
• If this product causes radio interference in a local wireless station used for identifying mobile
objects, change the working frequency or stop the emission of radio waves immediately. For
details on how to prevent radio interference, contact our service office.
• Although this product has been designed to resist high frequency electrical noise, if a radio
transceiver is used near the transmitter or its external wiring, the transmitter may be affected
by high frequency noise pickup. To test this, start out from a distance of several meters and
slowly approach the transmitter with the transceiver while observing the measurement loop
for noise effects. Thereafter use the transceiver outside the range where the noise effects
were first observed.
<Read Me First>
IM 01W02E01-01EN
ii

Advertisement

Table of Contents
loading

Table of Contents